Technical Data
Voltage: 220V
drive motor 1000 W / heat gun 3400 W
Temperature Wind Temperature20—650℃，Heating temperature while plastic extruding is 20—300℃
Warm-up heat gun volume 300L/min
Diameter of Welding Rod φ 3.0mm - φ 4.0mm
Thermoplasticity plastic HDPE, PP, PVDF, the PE can show the characteristic best.
It is forbidden to use for the plastic with electric conduction (PE-EL), which can bring electric conduction short circuit of the machine.
This machine is used for the fourth part of the barrel bath and the tube that accords to the standard of the DVS (Germany Welding Association).
It can once weld the welding line with width of more than 10mm and plastic board with thickness below 40mm.
|
|
|
|
|
